Genuine Whirlpool filter

EveryDrop Filter 2 (EDR2RXD1)

Fits the 3 refrigerator models listed below, each checked against linked sources.

Checked 2026-10-28

Brand
Whirlpool
Part number
EDR2RXD1
Also sold as
W10413645A, W10680605, W10744238, Filter 2
Replace
every 6 months or 200 gallons, whichever comes first (source)
Check genuine EDR2RXD1 on AmazonBrowse non-genuine alternatives

As an Amazon Associate I earn from qualifying purchases. We verify the genuine filter only. Non-genuine results aren't checked by us: confirm the listing names your model and an NSF/ANSI certification.

Refrigerators that use the EDR2RXD1

Browse all KitchenAid refrigerator water filters by model.

How to replace the EDR2RXD1

  1. Find the filter. Its location varies by model (inside the fresh-food compartment, in a door, or behind the bottom grille); your owner's manual shows where.
  2. Turn the old filter counterclockwise about a quarter turn and pull it straight out. Keep a towel handy for drips.
  3. Remove the protective cap from the new filter, line it up, push it in and turn it clockwise until it locks.
  4. Run water through the dispenser to flush out air and carbon dust, following the volume in your manual (often 2-4 gallons).
  5. Reset the filter indicator light (usually by holding the filter or reset button for about 3 seconds).

More detail and troubleshooting: How to Change the Water Filter in a Whirlpool Refrigerator.

EDR2RXD1 questions

Which refrigerators use the EDR2RXD1?

We've confirmed 3 models: KitchenAid KRMF706ESS, KitchenAid KRFC704FPS, KitchenAid KRFF507HPS. Each model page links the parts listings we checked.

What other part numbers is the EDR2RXD1 sold as?

W10413645A; W10680605; W10744238; Filter 2. All refer to the same genuine filter.

How often should you replace the EDR2RXD1?

Every 6 months or 200 gallons, whichever comes first. Replace it sooner if water flow from the dispenser slows noticeably.

Sources